This is intended for people who want to display their filament spools for any reason be it to keep them for weight checking or to re-spool later.

Version 1 (Left side of pictures) was a bit close together and works if you're fine with overlapping spools and saving space. 

Version 2 (Right side of pictures) Bit more space between to allow for larger spools, a Longer holder for spools that don't slide onto Version one (Only Matterhackers so far), and a deeper pocket on the back for command strips.

Print Settings:

.28mm Layer Height

3-4 Walls with 15-25 Percent Gyriod Infill (Personal preference is 3 walls 25 percent)

Grid supports with a .2 Interface works fine for printing just be sure for the internal section to get all the supports out (Using a small flathead screwdriver got them out easy for me), the lip on the end of the holder itself doesn't require any supports just the bottom sections where the mounts connect.

No need for brim or skirt of any kind.

Any Questions or suggestions feel free to ask or tell away.