Yellow Zil War Rig - Part 2 Trailer/Tanker by Black Jack

Black Jack

Hobby & DIY>Vehicles

GIF

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

16.8 h

5 plates

Boost

Released

Description

This is the Second part of three parts of the inspired model of a War-Rig. This part includes the trailer or tanker Unit of the Rig.

CLICK HERE TO FIND PART 1 OF WAR RIG

CLICK HERE TO FIND PART 3 OF WAR RIG

WAR-RIG ASSEMBLED IN FULL

Three ways to print

As single piece:- Please download STL file but there wont be any movements.
Multiple Pieces :- Download 3mf file with Full_dismantled.3mf.BEST QUALITY OUTPUT. Please use the 3mf file for assembly also.
Combined:- You may use any 3D viewer software like 3D builder in windows to merge components according to your printer and filaments. The sky is the limit for this. A sample file might be already provided for download. Please check for file ending with comined.3mf

ASSEMBLY OF TRAILER & MATING WITH CAB

Follow the GIF for mating of payload with truck cab.

NOTE The tolerances to some elements are zero which has been intentionally provided to friction lock the elements while not in movements. You may have to fine tune the tolerance from your end using scaling function in slicer to ensure good fit without compromising movements. This also applies for the pins that make rotation possible between elements. Please proceed with printing all the pins after testing printing a pin and testing the fit of a joint. You should be able to find the adequate scaling factor with this.

The main body is made hollow to ensure filament savings.

Supports should be provided as required.

Appreciate the makes uploads. Open for suggestions.

Comment & Rating (4)

@hogo_makerspace

Hi there, very nice models. ;-) Can you please tell me what scale it is. I would print some models in a 1:43 scale.

The designer has replied

@blackjack123

This being a fantasy item, the scale is a little odd to define but then again according to my calculations, It is approximately 1:26.5

@hogo_makerspace

Replying to @blackjack123 :

Thanks, that will help. I‘ll start to print it at the weekend.

@blackjack123

Replying to @hogo_makerspace :

Oh great. I wish that you share the make and your print profiles. It would be very helpful for future makers. I hope you have gone through the model readme. This is the 2nd part of a 3 part model. This is the trailer, the first part is the cab and 3rd part is the fuel pod. You should be able to find the links in the readme. Please make sure that you enable support before slicing. Also the profile I have uploaded is set to original scale as mentioned already and so some parts are cut to fit the print volume. It may not suit you but do certainly check it out as you can use it as guide to allocate colors to parts if you are building a new profile for yourself. If you need any help, please do ask. Always happy to help.

No more