Before you print: Please make sure that the support fits your material and settings. I was able to remove it as it is in the profile with tweezers. However, it is certainly good to adjust it differently (better).

I printed with PETG with Bambu Lab P1S and reduced the acceleration so that the printer is not so loud and does not wobble so much and use following general settings: 0,2mm layer, 3 walls, 3 upper layers and 2 lower layers, 10% infill.
Increase the infill if you expect rigid plates. It takes too long for me. That's why they are now somewhat flexible in my printout.

There is a distance of 4 cm between the shelves and the next level.