Share — copy and redistribute the material in any medium or format
Adapt — remix, transform, and build upon the material
Under the following terms:
Attribution - You must give appropriate credit , provide a link to the license, and indicate if changes were made . You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
ShareAlike - If you remix, transform, or build upon the material, you must distribute your contributions under the same license as the original.
What Mod / Fixes / Enhancement do i offer?
Please don't download the wrong one. Only those in the photos below is designed by me who painstakingly took a lot of time to measure carefully and design just to get it working. #SupportOriginal Love you guys for all the support so far!
Other Issues: Disappointed. It took all day to print. It looks great then I tried putting in batteries. They jammed and I cannot get one out. The tolerance on the chutes is too tight for some manufactures. When I drop in the first batteries they turn 90° and I had to dump them out. The photo shows the filament that blocks the chutes. I put one in and it is still stuck. I am poking around trying to get it out. I am very new to this. I will not be able to use it because of the blockages.
It’s almost impossible to remove supports from the “print in place version”. Go for the version that has only one set of battery slides and a separate side wall and print two of these and use some glue.