Click Switch Fidget Print-In-Place
Remixed by
Copyright Claim
Click Switch Fidget Print-In-Place
Remixed by
Boost
7
18
6
GIF
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
22 min
1 plate
Open in Bambu Studio
Boost
7
18
6
0
25
25
Released
Description
This is a remix from the Fidget Toggle Switch by user @kriswillcode.
Its design is cool, but I wish it was more clicky.
So I made a remix using Tinkercad.
This is a simple print without any support.
Comment & Rating (6)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Nice and fast
The designer has replied
1
Reply
Thx for your feedback.
0
Reply
Not as tight as the original (right) I think this is just because the notches have been added using a subtraction rather than an addition to the original model. It's just over a mm off the normal height, making it feel loose and unsatisfying 😢
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
the interface of the ridges and the point needs to be a little closer for better clicking
The designer has replied
1
Reply
Thank you for your feedback. I'll take a closer look at this in the next few days.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld