Needed to raise my SE Mini a little so it could sit under my monitor due to the monitor base so designed this. Print 2 and they sit on the rubber feet, the base is not as deep as the rubber feet to hopefully reduce any vibration, you can then fit new rubber feet to the bottom of the print if required.

Simple design but worked fine for me.

Print Settings

Printer Brand:

Bambulabs

Printer:

Bambu P1S

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

15%

Notes:

Filament should matter, even TPU would be fine.

Category: Office