Screw Style Refillable Spool for AMS
Remixed by
Copyright Claim
Screw Style Refillable Spool for AMS
Remixed by
Boost
39
77
17
Print Profile(1)
Thick bottom layers , added walls
Designer
5.6 h
2 plates
Boost
39
77
17
1
115
201
Released
Description
This is a remix of the original Bambu reusable spool with a screw center so you can keep cardboard out of your ams. you can rip the sides of the cardboard off without having to worry about trying to removed the center of the cardboard spool, simply screw this on either side and it is AMS friendly
Documentation (1)
Assembly Guide (1)
assembly guide.pdf
Comment & Rating (17)
All
Print Profile
Thick bottom layers , added walls
this print has saved me a lot of work from re-spooling..
(Edited)
1
Reply
Print Profile
Thick bottom layers , added walls
I really like this screw style. I wish there were different spacers to work with different sizes
2
Reply
Print Profile
Thick bottom layers , added walls
Very quick, simple solution for cardboard spools.
1
Reply
Print Profile
Thick bottom layers , added walls
it's worse than the cardboard it's supposed to replace. giving 3* because settings were ok
0
Reply
Print Profile
Thick bottom layers , added walls
I like the design for it's simplicity and it fits all refills you can buy, but it was slightly difficult to get it lined up in the middle and get it tight enough
0
Reply
Print Profile
Thick bottom layers , added walls
quick print and good
0
Reply
Print Profile
Thick bottom layers , added walls
Perfect fit between the two halves, smooth spinning
0
Reply
These work great! Very easy solution.
0
Reply
Print Profile
Thick bottom layers , added walls
(Edited)
1
Reply
Print Profile
Thick bottom layers , added walls
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld