Combination of filament swatches/samples and filament clip.

The text is freely editable in bambu studio.

There is a variant for 4 and 3 text lines. You can use these lines completely free.

I prefer the 4 line variant with: Brand, filament type, colour and factor K.

IMPORTANT:

I have only 3 spools in use: Sunlu plastic, overture cardboard and eSun cardboard. I need your help to make the watches for other brands, if following dimensions are different to the existing versions:

If dimension A and B not match with the different print profiles (see dimensions in the print profile name), than write your dimensions with the brand name in the comments. The thickness should be measured with caliper. I need a precise measurement!

If other brand fits to the existing profiles, than write a comment too. In this case I could edit the print profile discription. Thank you in advance!

Instruction for text editing/printing:

Step 1: Download the correct print profile and open it in bambu studio

Step 2: Choose the 3 oder 4 line variant

3 line variant:

Step 3: Click on the first text line:

Step 4: Click on the text edit button and than edit the text in the yellow marked field:

Step 5: Click again on the text edit button to close the window

Step 6: Right click on the edited text and click Middle (Mitte):

Step 7: Hold shift and press arrow up 8 times. The text is now aligned correct again.

Step 8: Repeat step 3 to 6 again for the middle line (Filemant type). You don’t need the arrow keys this time because the lign is exact in the middle.

Step 9: Repeat step 3 to 7 again for the third line (colour). But this time hold shift and arrow down 8 times.

Step 10: Click on an area without text to mark the complete part:

Step 11: Press Ctrl (Strg) + C for copy the part.

Step 12: Click on the empty print plate 3 and click Ctrl + V for paste:

Step 13: Now press this button:

Step 14: Click on the surface with the text. Then it should be located in this position:

-

Step 15: Press again on this button to stop the function:

Now you can print youre edited filemant swatch.

If you want to use the 4 line variant:

The functionality is the same but the text alignment is different of course. Instead of Shift + 8 times up or down you need to press 12 times up/down for the first and last line and 4 times up/down fort he lines 2 and 3.

Overview:

The third print plate (for printing) is configured for „print by objekt“. So you can copy 4 swatches at the same time of these print plate and set up the correct AMS slot for each of them. After that you can print these 4 swatches one after the other without intervening: