DISCLAIMER: DO NOT USE IT AGAINST ANY LIVING CREATURE
I'm not Responsible for any Damage Caused by This.

Step File Included!

Just a little fun Project I Made.
I Always Wanted to make a cheap DIY Taser, now with the power of fusion 360 and a 3d printer I was finally able to make one myself.
All parts together cost only around 6€
i Designed the Taser to be Customizable by colors and so it is Rechargeable.

There are already supports included where they are needed, so you don't need to enable supports. You can just remove them with a knife or pliers.

IMPORTANT
Solder the High Voltage Generator on the same Point where the Battery is Soldered. if you Solder the High Voltage Generator on the “out” hole, you Destroy the Module and the Charger!!!
Wire Diagram in the Pictures included!

Parts needed:
5x M3 screw
1x M3 Nut
2x M4 Screw (30mm)
4x M4 Nut
1x Li-ion charger module https://www.ebay.de/itm/273504945334
1x High Voltage Generator https://www.ebay.de/itm/232565141309
1x Microbutton 6x6x8.5mm (in German its called "Microtaster")
1x Micro Switch https://www.amazon.de/gp/product/B00CQNQN4Q/

Donate if you want, need more Filament for other Projects/Prototypes ;)