PTFE Adapter Plug for Sovol Filament Dryer
Copyright Claim
PTFE Adapter Plug for Sovol Filament Dryer
Boost
10
9
9
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
13 min
1 plate
Boost
10
9
9
0
29
32
Released
Description
The PTFE Adapter Plug for the Sovol filament dryer is a perfect fit to securely hold your PTFE tubing during prints. The PTFE Adapter Plug also creates an airtight seal when the PTFE tube is inserted. Please consider using TPU for this print. I have not tested other filament types with this design. TPU has the added advantage to easily create airtight seals.
Comment & Rating (9)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Look, I don't know what other reviewers are talking about.
I unscrewed the original filament hole thingies (which suck by the way, I'm sure you already know) and slapped these TPU bad boys in.
The fit was... not snug -- UNTIL, I pushed the PTFE tube through. It expands just a tiny tiny amount, and now its perfect. I can tell you big-brained that.
And for the record, I DID use extra PTFE tubing that my Bambulabs printer came with. Went in just fine. 👍👍👍
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
quick print
The designer has replied
0
Reply
Thank you for the review. Can you elaborate on why your rating is 3/5 stars? Anything that can be improved upon?
0
Reply
the extra tubes that came with my printer wouldn't fit in. I'm sure it's just they weren't the ones you designed them for!
0
Reply
Replying to @Technohierarchy
It worked with standard PTFE tubes. What kind of goofy tubes are you using? Adjust that rating if you're using something non-standard. Be a chad.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works Great only way it would be better is if it screwed together like the original
(Edited)The designer has replied
1
Reply
Thank you!
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld