Clasic Karambit with a complete belt holster for Airsoft/Training use. The blade, handle and holster are divided in half to make it easier to print and to have a better appearance after assembly. Also the knife clip itself to the holster thanks to the round projection on the handle.
Print all the parts with a durable material such as PETG/ABS/ASA and the blade in TPU. Supports are needed to print both halves of the handle.
Assembly:
1.- Glue the two halves of the blade and the back ring. Then place them between the two halves of the handle and glue all together.
2.- Before joining the two halves of the holster, glue two M4 nuts to the inside of each half.
3.- The holster can be attached together with just 5 self tapping 2mmx8mm long screws. Although it gives better results also using glue.
4.- Insert 4 M3 nuts into the belt holder parts of the holster. And join them with 4 M3x8mm screws.
5.- Finally, the belt holder is attached to the holster in the desired position with an M4x5mm screw.