I designed this simple stand to put my Losi LMT Grave Digger Monstertruck on it.

This way it can be safely stored without the shocks and wheels deforming under the load.

It requires no tools and is printed in one piece.

The base has a size of 130 x 130 mm, while the top measures 80 x 80 mm to perfectly fit the center base of the LMT chassis.

It's 100 mm high to lift the wheels off the ground and allow the shocks to fully decompress.

I printed it with black PLA from Eryone at default 0.4 mm nozzle settings with 0.2 mm layer height, 10% infill, 4 wall lines and tree supports.

Printing time is around 4 ½ hours on the P1S.