Keep your favorite glue stick and a backup close at hand with this dual glue stick holder for the honeycomb storage wall system. Fits into two empty inserts for the HSW system as well. Fits the 21/22g glue sticks or anything under 27mm diameter.

Original model based off of the @juicebox design for the Skadis system, but fit for HSW. Also made a few changes in design for easier printing without supports and flattened the bottom so the sticks wouldn't wobble.

Printing Notes:

• Layer height: 0.2mm
• Filament: PLA
• Infill: 15%
• No supports

This is part of my version of the Honeycomb Storage Wall by RostaP.

For the full video of my HSW wall check it out on the Fix This Build That YouTube channel: https://youtu.be/NsBqs3TRjqQ