Sonic Brush Lead Screw Cleaner
Remixed by
Copyright Claim
Sonic Brush Lead Screw Cleaner
Remixed by
Boost
2
7
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
18 min
1 plate
Open in Bambu Studio
Boost
2
7
2
0
12
8
Released
Description
Had some left over old Sonic care brushes so I made this.
Designed to have brush fit very snuggly.
Print on its side with only support from the Bed at 15 deg.
Comment & Rating (2)
All
Thank you for designing this. Made in Hatchbox PETG. I also found the fit extremely tight to a point where I had to use a screwdriver to lever it out. Ended up bring the STL into Fusion 360 and just scaling the "D" shaped end down 0.97 in the cross section directions. Now it's just tight enough.
0
Reply
Had to shave the spigot down a little but then a perfect fit and works very nicely. Thank you!
1
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld