Chinook Helicopter - No Supports - Print in Place
Remixed by
Copyright Claim
Chinook Helicopter - No Supports - Print in Place
Remixed by
Boost
47
96
20
Print Profile(1)
0.24mm layer, 4 walls, 25% infill
1.8 h
1 plate
Open in Bambu Studio
Boost
47
96
20
0
183
158
Released
Description
Prints with no supports, slow down for best results. Rear door does not open.
Also available:
Original PIP Helicopter: https://www.printables.com/model/510524-print-in-place-helicopter-no-supports
Comment & Rating (20)
All
Print Profile
0.24mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.24mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.24mm layer, 4 walls, 25% infill
Good print, rotor blades could be a bit thicker. Broken off quite quickly when handled by kids. Good print quality though.
0
Reply
Print Profile
0.24mm layer, 4 walls, 25% infill
prints well
0
Reply
Print Profile
0.24mm layer, 4 walls, 25% infill
Lovely gift for the neighbours son on his birthday. I made the mistake of printing with supports. Lucky PLA Tough is tough. They came out cleanly with some effort.
0
Reply
Print Profile
0.24mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.24mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.24mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.24mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.24mm layer, 4 walls, 25% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld