This is Version 2 of this mount which has had very minor changes made after a year of use of the original one I created.

I designed this to utilise the A1 Spool tensioner from the AMS lite to create a quick easy spool holder for the X1C or P1 Series.

It allows for smooth turns of the spool while holding mild tension on the filament.

Print file tested on Bambu's smooth high temp plate using Bambu PLA-CF material.

Fitting instructions; ideally use a threading tool to re-thread the M10 push fit fitting on the spool mount, this is a tight fit. It can be fitted without re-threading it with a little force. The 4to1 adapter bracket fits in reverse to how its printed on the plate, these can normally be pushed in place by hand depending on your filament calibration, if not you can gently tap them in place with a small hammer.

Many hours went into creating this and a fair few test prints have been done to create the perfect profile to get it too print correctly in PLA-CF.

Required items

First plate of this print.

1x M10 Through push fit.

2x 20mm M3 Countersunk screws

1x AMS lite Rotary Spool Holder (YELLOW). AMS lite Rotary Spool Holder | Bambu Lab UK

Extras required AMS Hub extension

1x Bambu Lab 4to1 Adapter. Bambu 4-in-1 PTFE Adapter | Bambu Lab UK

1x 12"Inch Bambu PTFE Tube.