Emergency dust remover for lightning or usb ports
Copyright Claim
Emergency dust remover for lightning or usb ports
Boost
155
271
30
Print Profile(3)
0.24mm layer, 2 walls, 15% infill
Designer
7 min
1 plate
A1 Mini - 0.2mm layer, 2 walls, 15% infill
Designer
6 min
1 plate
P1S 0.2mm layer, 2 walls, 15% infill, brim
8 min
1 plate
Boost
155
271
30
0
286
76
Released
Description
This is for dust emergencies! It is optimiesed for speed and prints ectremely fast. So that you can start charging your usb c, or lighning port again.
Comment & Rating (30)
All
Print Profile
0.24mm layer, 2 walls, 15% infill
Simple and usefull
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Great little tool
0
Reply
Print Profile
A1 Mini - 0.2mm layer, 2 walls, 15% infill
Cool.
0
Reply
Print Profile
A1 Mini - 0.2mm layer, 2 walls, 15% infill
Great model! Saved me from my dust emergency 😅
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Did not fit my Samsung USB c charging port. Printed fine though
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
good model.
0
Reply
Print Profile
A1 Mini - 0.2mm layer, 2 walls, 15% infill
Printed Lightning fast, cleared everything (Never Good cleaned in like 3 years and holy was there big chunks in there)
0
Reply
Print Profile
P1S 0.2mm layer, 2 walls, 15% infill, brim
works and does its job
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Great :)
thx
0
Reply
Print Profile
P1S 0.2mm layer, 2 walls, 15% infill, brim
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld