PUZZLE - Minnie Mouse

This design was a Patreon subscriber request. To make the full gift package, you'll need to print the box lid and bottom linked below.

If you only have one pink you could use it for both Magenta and the soft Pink that I used.

The Puzzle Box Lid for this puzzle can be found here:
https://makerworld.com/en/models/496984#profileId-411351

The Puzzle Box bottom can be found here:

https://makerworld.com/en/models/446736#profileId-353234

And other puzzle files I have created can be found here:
https://makerworld.com/@CanadianGamer/collections/988102

-----------------------------------

***IMPORTANT***

In my print profile the files are set up to make the puzzle. If you load my print profile, be careful about adjusting the locations or you may change the puzzle cut. If you download the files, you will need both the STL and the Puzzle Cutter, and you will need to cut the puzzle yourself.

Something that Bambu has done in the last update has made hueforge designs give a floating regions error. You can ignore this error.

In my print profile I have used a height range modifier (HRM), which means that the first 4 layers of the model will print with a 0.16 layer height, and switch to a 0.08 layer height for the details. If you use my uploaded print profile this will save you time on your print as the first 0.64mm is just to provide stability to the print for display. This means that the layer heights listed below in my printing instructions will not match my print profile (they will be off by 3) but the mm heights will still match! Do not change the print profile to match or it will not look the same!

If you resize the model make sure you do NOT scale the Z axis or the print colours will not be in the same position

Printing Instructions

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA Generic Black 
PLA Bambu Basic Magenta 
PLA BambuLab Matte Sakura Pink
PLA BambuLab Matte Ivory White

Swap Instructions:
Start with Black
At layer #12 (1.04mm) swap to Magenta
At layer #16 (1.36mm) swap to Sakura Pink
At layer #19 (1.6mm) swap to Ivory White for the rest.

---------------------------------------------------------------------------------------------------------------------

Commercial license's to sell my prints are available on my Patreon:

https://www.patreon.com/CanadianGamer3DPrintsEDM

As part of your membership you will also have access to exclusive files available only on Patreon.

---------------------------------------------------------------------------------------------------------------------