Update 6/29/22: Added a version with a centered ¼-20" thread and no boss (i.e., MagSafe compatible). Use caution – this will be less secure than the SlimLink version.

Update 4/27/22: Added a version with a centered ¼-20" thread

A magnetic mount to adapt Peak Design's Mobile Case standard straight to their Capture V3 clip product in a single part.

Requires 4x 10mm x 3mm refrigerator magnets and a pause at the appropriate layer to embed them in the print.

I recommend you use Peak Design's Mobile case and retain the small square boss on the phone side of this adapter – this will make the magnet joint much stronger by preventing sliding in any direction.

This should also be compatible with MagSafe natively without a Peak Design case if you remove the boss, but I haven't tested it and wouldn't recommend it for actually carrying a phone on a Capture – not secure enough IMO.

My first print so far with this design was with:
- Prusament PLA Galaxy Silver
- 0.15mm layers, QUALITY preset
- 4 perimeters
- 30% gyroid infill
- supports to the base only
- printed with the boss/phone side down on the plate