Disc Brake Coaster w/ 55mm center cutout for cork

Remixed by

Disc Brake Coaster w/ 55mm center cutout for cork

Remixed by
Boost
3
18
2

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
6.8 h
3 plates

Open in Bambu Studio
Boost
3
18
2
0
13
4
Released

Description

The rotors have a negative cylinder added to the center which leaves a 55mm round by 4mm deep hole to insert cork. (I have a laser engraver, so I used LightBurn to cut a coaster down to size then engrave the images on to the cork.) The rotors thickness was also increased to accommodate for a 4mm thick cork coaster and still have a surface on the bottom. 

 

I also increased the size of the caliper  to accomodate the increased size of the rotors.

Comment & Rating (2)

Please fill in your opinion
(0/5000)

Why does the file look like the standard rotor? Not recessed for the cork coaster? Do you have a picture without the cork?
The designer has replied
1
Reply
there's a negative space cylinder where the cork gets inserted into the printed rotor. I do not have a pic of just the rotor, I made these for a buddy. if you open the file and slice it, you can see in the preview section where there will be room for cut cork to fit.
0
Reply
No more