This LED strip holder is designed for a standard 1 meter long LED strip. I made it as a light bulb for a lamp so that i get a nice and even light in all of the lamp with a cheap LED strip.

In the end it has a cable/wire holder so that the wire for the LED strip can't be pulled out. It uses two M2x6, M2x8, M2x10 or similar screws (Longer M2 screws can be used as there is hole all the way through). The whole thing measures 27,9 mm in diameter and is 163,5 mm tall.

It can be printed without support using the “0.12mm Fine” preset. If going over 0.12 mm layer height I recommend using support in the middle