A wibbly wobbly timey wimey model for all the Whovians out here!
This is another Hueforge Hybrid print, where the Tardis ‘pops out’ of the print for a little personality. This print combines Hueforge filament painting methods with traditional 3D printing to create a lovely pop art style print.
Note: If you are using the 3MF for one click printing, all settings will have been applied to the model. I used 5 filaments for this on one AMS and swapped one spool out of the AMS when the colour was finished printing for the 5th colour.
Note 2: This print also has steep overhangs with no supports. If you're not confident in your printer handling supports with my 3MF file settings, do not use the one-click printing function and import the 3MF file into your slicer and adjust the settings for the ‘Tardis_Export3.STL’ part of the assembly to suit your own supports/overhang settings.
If you are not using the one-click 3MF, the print instructions and recommendations are as follows:
Filament Instructions
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm
Filaments Used:
- PLA Kingroon Black Transmission Distance: 0.4
- PLA+ Polymaker Starlight Neptune (Blue) Transmission Distance: 1.8
- PLA CC3D Orange Transmission Distance: 7.4
- PLA CC3D Lemon Yellow Transmission Distance: 8
- PLA Kingroon White Transmission Distance: 8
Swap Instructions:
- Start with Black
- At layer #8 (0.76mm) swap to Starlight Neptune (Blue)
- At layer #9 (0.84mm) swap to Orange
- At layer #15 (1.32mm) swap to Lemon Yellow
- At layer #17 (1.48mm) swap to White
- At layer #24 (2.04mm) swap to Black
- At layer #27 (2.52mm) swap to Starlight Neptune (for the Tardis!)