I present a set for lifting the upper window for Bambu Lab X1C, which includes:
1. Limiter 1 - 1 pc.
2. Limiter 2 - 1 pc.
3. Base - 1 pc.
3. Handle - 1 pc.
4. Arm - 1 pc.
5. Pin - 2 pcs.
In addition to the above-mentioned elements, the correct assembly kit requires four M3x8 screws.
The limiters protect the glass from falling/slipping out of the printer body when lifting it. They must be screwed to the back of the device using the existing threaded holes, using M3x8 screws, two screws per stop. The assembly method is shown in the photo.
Place the handle for lifting the glass between the glass and the original handle on the glass, and secure the whole thing with the original screws that previously attached the glass handle (see photos). The handle has a "tooth" that protects it from falling out of the rectangular hole in the arm.
Connect the base and the arm together using pins and push them into the holes provided for this purpose, as shown in the photos. Press the base connected in this way onto the printer housing, at the top, in front of the glass.
You can see the entire system in the photos.
Using this system, you can raise the upper window to five different heights.
The whole thing was printed in red PLA