Fixed PTFE Coupler for Bambu Lab P1P / P1S (PC4-M10) by suit1337

suit1337

3D Printer>3D Printer Parts

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

Regular print, 0.2mm layer, 2 walls, 15% infill

17 min

1 plate

4.7(3)

Boost

145

Released

Description

Replaces the rotating coupler with a fixed one - if you intend to mount you spool holder on the side of the printer, you might be printing the Side Filament Guide Arm for P1P instead

BOM

2 x original screws for PTFE coupler
2 x PC4-M10 connectors (Amazon Affiliate Link)

Assembly:

print both pieces, the Adapter Core needs to be printed with the minimum possible layer height for a smooth surface
insert the Adapter Core into one of the connectors and attach it to the other one, it should fit snug without much wiggle - if it is too small or too big, scale the model by a few percent
separate the 2 pieces again and put them into both ends of the Coupler
attach 2 PTFE-Tubes on either end and test, if the Filament slides through smoothly
if everything works, remove the pieces again, add a small amount of glue to the internal hex shape and insert the connectors again
install it onto your printer with the original screws

Comment & Rating (9)

@user_2797432865

wondering where you found the ptfe inlet guide to the p1p? thx

The designer has replied

@suit1337

https://www.printables.com/de/model/364801-bambu-lab-p1p-cable-drag-chain-assembly-59-updated

@Dee.45

my fittings were 4mm ID so I had to scale the core down massively causing its choke to create interference which could cause issues, trying some taped sand paper on some filament to widen it update, gave up on that over the top stupidity and doing the sane thing and just modelling it now xP

(Edited)

The designer has replied

@suit1337

you can just scale it in bambu studio and add a modifier cylinder on the inside (with 1,75 mm diameter) to achieve the same without husteling with modeling