BC Lions - CFL Hueforge

The rest of my Football (CFL / NFL / XFL) Hueforges can be found in this collection here:
https://makerworld.com/@CanadianGamer/collections/549656

-----------------------------------

The pictured Frame is a friction Fit design here for 200x200 Hueforges
https://makerworld.com/en/models/381229#profileId-281475

In my print profile I have used a height range modifier (HRM), which means that the first 4 layers of the model will print with a 0.16 layer height, and switch to a 0.08 layer height for the details. If you use my uploaded print profile this will save you time on your print as the first 0.64mm is just to provide stability to the print for display. This means that the layer heights listed below in my printing instructions will not match my print profile (they will be off by 3) but the mm heights will still match! Do not change the print profile to match or it will not look the same!

If you resize the model make sure you do NOT scale the Z axis or the print colours will not be in the same position

And if you scale it down, I have frames for 150x150 or 100x100 here:

https://makerworld.com/en/models/173529#profileId-190705

Printing Instructions---

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.64mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
PLA Generic Black 
PLA BambuLab Basic Orange
PLA BambuLab Basic Silver 
PLA BambuLab Matte Ivory White 
 

Swap Instructions:
Start with Black
At layer #11 (0.96mm) swap to Orange
At layer #19 (1.6mm) swap to Silver
At layer #22 (1.84mm) swap to Ivory White for the rest.
 

-----------------------------------

Commercial license's to sell my prints are available on my Patreon:

https://www.patreon.com/CanadianGamer3DPrintsEDM

As part of your membership you will also have access to exclusive files available only on Patreon.

-----------------------------------