This is a memorial grave marker that I made to be used at my grandmother grave site. I made the stake out of PETG so if it was used in the ground it would last longer. Due to colors that I had available at the time, I used PLA for the heart since I did not have time to order red and white PETG. The stake just goes in the openeing on the back of the heart with a thing layer of glue in it. You cannot see the stake thru the heart unless the sun is directly behind it. If you print with a higher infill, then the sun will not pass thru as easily. This item works in either the ground or in some sort of floral arrangement.