I designed this Sand Vault to keep your valuables safe while you play in the ocean. Screw it down into the sand insert your valuables into it via screw on lid then put towel over it and go off and enjoy your activities without worry of your stuff getting stolen.
This can be printed at 125% to accomodate most modern phones.
My print settings: .24 draft layers, arachne walls, 3 walls, 10% adaptive cubic with infill combination (checked), top and bottom surfaces = concentric
Support: normal(auto) > snug > Thresh Angle=35 > on build plate(checked) > Remove small overhangs(checked)
These support settings made the inside of cup pretty clean and easy to remove with some needle nose pliers
Overall the .24 gives it a rough look but its going to get rougher looking in the sand anyhow.