Concept

This model allows to write two text :

• One from the front point of view
• One from the top point of view

It works better if the texts has roughly the same length but it is not mandatory.

Special charaters are supported

Exemple : “ALT key + 3” will draw a heart

Parameters

• TextSup : The text to write from top point of view
• TextInf : The text to write from front point of view
• FontHeight : The height of the font.
  • Because the texts has to do the same length, the smaller text will have bigger font height
• FontSpacing : Control the space between letters.
  • 0 - all letters are on top of each other,
  • 1 - Normal spacing
  • Recommendation : 0.78 to allow letters to barely touch
• SupportingLine : Draw a line at the bottom of TextInf.
  • This allow TextInf to have spaces
  • In millimeters
  • 0 - disabled
• SmoothModel : Control the smoothness of the model
  • This is very resource heavy. I don't recommand using it.
  • 0 - disabled
  • 1 - maximum

Printing

Depending on the actual text, you may need some support. (I now hate letters “E” and “G” lol)

I recommand lowering layer height if you have a lot of overhangs.

Bye

If you have good ideas of texts, please post a profile !