Version 1 of my 6 rod carrier. This version is simpler than v2, but takes longer to print the main body and uses more material, however there is less assembly in v1. V2 has more assembly, but uses less material overall and has larger rod tubes.

Check out version 2 here:
https://makerworld.com/en/models/505647

Version 1:

This is a rod carrier/rack that can accommodate up to 6 spinning and/or baitcast rods. 

The handle is offset forward for better balance when loaded up.

Can be used for transport, as a stand with the legs, or as a rack for vertical storage.

The legs can be stored inside the rack for convenience.
 

The attached profile is set up for PLA+ - but ASA or ABS is strongly recommended if this will be used in the harsher outdoor conditions.