Search models, users, collections, and posts
Key-Float
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 5% infill
Designer
1.7 h
3 plates
Open in Bambu Studio
Boost
42
102
2
1
75
28
Released
Description
A key-Float/key-bobber to keep your keys safe when out and about on water.
Tested with 70g of wheight, aprox. 4 keys and it floats fine.
Glue is not required because when you mount the keyring you cant pull the float apart, however, to keep things rattle free, a small amount of glue between the two halves of float and the two pin halves is recomended.
Print the pins with 100% infill
I hope others will test out som other color combinations.
Happy printing :)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)