Module 1 Differential - Desktop Fidget Toy remix
Remixed by
Copyright Claim
Module 1 Differential - Desktop Fidget Toy remix
Remixed by
Boost
3
10
2
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
3
10
2
0
23
9
Released
Description
This is a minor remix of the Module 1 Differential - Desktop Fidget Toy by Mervill.
I made the following changes for this remix:
- Reduced the diameter of the Planet Gear Axle to make it easier to assemble without needing to ream out any holes.
- Trimmed the inside edges of the Circlip to make it easier to install. When using standard PLA (not PLA Tough or PLA+), the original design would snap in two when I tried to install it.
- Added an optional Crank Handle to make it easier to rotate the mechanism by hand.
I recommend using a smooth build plate to lessen friction between sliding surfaces. A light oil on the pivot points will help the mechanism rotate smoothly.
Comment & Rating (2)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
I think this is a great tool for teaching people how a differential works. The shafts are a little bit tight in their clearance, causing quite a bit of friction however, it functions it printed up perfectly.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld