Introduction
The original model is designed for printers with a 250x250mm bed.
If for any reason it doesn't fit on your bed, you can resize the model to the size you want from your slicer.
It consists of two parts, the lamp body (body.3mf) and the rear cover (lid.3mf).
There are two rear back/lid plates:
- Lid with hole, Loose fitting = near 0.3mm separation between light body and rear back plate. Recommended in most cases, although it will probably require fixing it with adhesive/glue gun so that it does not fall.
- Lid with hole, Tight fitting = near 0.1mm separation between light body and rear back plate. It depends on your printer. If properly calibrated, the lid will fit with very little pressure. It does not need glue to stay attached. If your printer is not properly calibrated or your filament expands too much, it may not enter at all or not at all.
Sometimes I include two lids, with and without a hole (choose the one you want, I recommend printing the Lid with hole whenever possible, to be able to remove the LED cable).
If the back cover does not have a hole, you can easily make it from Bambu Studio, or from any other slicer you use.
----
You will need
Optional, but recommended:
----
Assembly instructions
You can follow either of these two videos to assemble the lamp. It's very simple, you stick the LED strip inside and that's it. If you want, you can use aluminum tape to improve the lighting, although it is not necessary:
----
Printing settings
Following braga3dprint recommendations, you can start with these settings in Bambu Studio:
Important!
Remember to remove the purge line at the start printing, otherwhise it will ruin the print.