Waste bin / Poop bin for A1 - Space effective.
Copyright Claim
Waste bin / Poop bin for A1 - Space effective.
Boost
142
262
112
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
5.4 h
2 plates
Open in Bambu Studio
Boost
142
262
112
49
396
313
Released
Description
Update: Added version that is compatible with the AMS Lite Top Mount.
My version of a poop bucket for the A1. I designed it with the following goals:
- Doesn't add much to the printer's footprint so it can be used in an enclosure if needed.
- Stays in place even when the printer is on a 400*400 concrete slab and the bucket partially in the air.
- Doesn't block the electronics vent holes.
- Easy print.
- Spiral vase model version available in files.
Bin Dimensions:
Standard version: 250*80mm+overhang
AMS Lite top mount version: 225*80mm+overhang
75-85mm height
Check out the Poop deflector designed by ThreeD-Michael that I am using: https://makerworld.com/en/models/123164
Comment & Rating (112)
All
Boosted
Fits my special needs perfectly. And nice and helpful support from designer.
The designer has replied
1
Reply
Thank you for your feedback :D
Can I use one of your pictures to show this version?
0
Reply
Boosted
Replying to @Criticalprint3d
Of course, feel free. Do you want an additional photo only showing the bin?
0
Reply
Boosted
Works perfectly in my limited area.
The designer has replied
2
Reply
That's great! Thank you for the boost :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed without defects and fits my A1 perfectly!
The designer has replied
1
Reply
Thank you for your feedback :D
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
This was my very first print after getting my A1 put together and I printed it on sport mode. It printed fantastic. One of the rounded edges looked like it over extruded slightly as there's like a bump there, but the entire rest of it looks perfect. Printed in Elegoo Rapid PLA Plus in white. It's also perfect for the tight space I have.
The designer has replied
1
Reply
Glad you like it!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
So good and Nice
Thank you very much
The designer has replied
1
Reply
Thank you!
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
turned out great!!
The designer has replied
1
Reply
Thank you for the boost!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
avrei messo dei supporti per la parte a sbalzo ma va bene lo stesso
The designer has replied
1
Reply
I didn't need supports for this, did you change any of the settings?
0
Reply
Boosted
Perfect. Thanks 😎👍
The designer has replied
1
Reply
Thank you for the boost :D
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect!
(Edited)
The designer has replied
1
Reply
Thank you for the boost!
0
Reply
Boosted
yeah, actually need this useful compact bucket for save space.
The designer has replied
0
Reply
glad you like it and thank you for the boost :D
0
Reply
Boosted
Replying to @Criticalprint3d
printed,but conflict with "amslite top mount"...
0
Reply
Replying to @orangetech
Oh, I don't use that. I'll see if I can make a compatible version.
0
Reply
© 2024 MakerWorld