Command Strip Hook (Large)
Copyright Claim
Command Strip Hook (Large)
Boost
29
67
24
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
3.9 h
2 plates
A1 Mini version (1 hook only)
Designer
1.5 h
1 plate
0.6mm nozzle, 0.24mm layer, 2 walls, 40% infill
4.9 h
2 plates
Boost
29
67
24
0
102
154
Released
Description
Use my print profile for best results, I cannot guarantee print profiles by others.
Hey folks, here is an easy to print hook you can put on your wall and easily remove without any marks. It uses the great 3M Command Strips and costs less than $1 in filament.
You can get Command Strips at Amazon-- about 50 cents apiece.
Really easy to assemble. Align the print as shown in the plate picture. I used PLA with default settings on my Bambu. Very strong when assembled correctly. See pictures for details on assembling.
Comment & Rating (24)
All
Great file, looks good! Hopefully it sticks to the wall as well as it prints. 👍
The designer has replied
1
Reply
unfortunately, you've installed the back plate upside down.
0
Reply
Replying to @chippwalters
ha! yes, I realized that when I went to hang it up. got that fixed and it is holding up well!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Provided Print Profile Prints Great! Thank you for sharing.
The designer has replied
1
Reply
Yeah, one of my favorites.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Put these on the bathroom door for the kids to hang their towels.
The designer has replied
1
Reply
Looks great.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Thank you, this design is genius and looks very nice.
(Edited)
The designer has replied
1
Reply
Much appreciated!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works good. using one command strip in the middle let's it wobble a little because it's not flat on the wall. putting two command straps works best keeping it flat. good hook for not drilling into the wall and hard mounting
The designer has replied
0
Reply
Are you sure you're using the wall mount insert correctly? Should work fine with the designated command strip.
0
Reply
Print Profile
A1 Mini version (1 hook only)
neat design
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great!! Very Slick looking as well! Great Job!!
X1C 220/65 PLA
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works great, Thanks!
0
Reply
Print Profile
0.6mm nozzle, 0.24mm layer, 2 walls, 40% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld