Intro 介绍

This part mainly aim to install the InfiniSkadis together and stick it on the wall without drilling holes.

本部件用于连接koru的Inifiskadis并提供平面以便用无痕胶把洞洞板粘在墙上。

Requirement 需要的部件

M4*20 Countersunk bolts

M4*20 沉头螺栓

M4 Nuts

M4 螺母

Vise

老虎钳

3M Command or other wall mounting glue

3M高曼，银背清拉胶（推荐）或者其他墙面无痕胶

Installation 安装

1. Press the nut into the reserved hole using a vise. 用老虎钳把螺母压进预留好的位置
2. Thread the bolt: Skadis → connector → wall mount part(face the side with ring). 用螺栓连接洞洞板和这个打印件（有圈圈的一面朝洞洞板）
3. Tighten the screws and make the bolt tail just flush with the nut. 拧紧螺丝，让螺栓屁股刚好不超过螺母
4. Stick the glue, cover the nuts. 粘胶，把螺母覆盖住，胶的易拉手柄要外露方便移除
5. Stick it to the wall. 粘墙上

Refer 相关模型

InfiniSkadis A1mini low-cost and Invisible Screws by koru

https://makerworld.com/en/models/462632?from=search#profileId-371160