Big Simple box with lid by Snigzou

Snigzou

Tools>Organizers

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

9.7 h

3 plates

5.0(2)

Boost

Released

Description

A big (5.6 L) box to store whatever.

Features a nice lid which provides a tight seal (not hermetic!), with handles for ease of use.

A rice cup is also provided and was modeled in such a way that fully filling it with rice will give you a portion for one (~ 50g for white rice).

Health concerns :

You might think this model is unsafe to store food or whatever in it. If this is the case, do not use this model to store anything in it. Don't even print it. I'm a description, not a cop.

I personnally clean out every box I print before putting inside food. I never put wet food but only use it to store dry foods. And I wash my rice before cooking it. My opinion is that it's good enough, yours may differ.

Comment & Rating (7)

@lampert

The part in contact with the box roof is narrow. It comes off after putting on a few roofs. The box wall should be the same size and the roof should go on it. This is a waste of material, because the wall is too thin, it will probably separate sooner or later.

(Edited)

The designer has replied

@Snigzou

I'm sorry you experienced this. As you're the first one to report it, and it never really happened to me on my multiple prints, can you make sure it's not related to your filament? The layer delamination might happen because of moisture or too low of a printing temperature.

@lampert

Replying to @Snigzou :

Filament is new, printed at 230 degrees, maybe it would have stuck together better with a smaller nozzle. It will be fine in a box, but I can't use it as a lockable box.