PETG Transparent Bambulab - Clear Glass - Profile
Copyright Claim
PETG Transparent Bambulab - Clear Glass - Profile
Boost
71
173
41
Print Profile(1)
0.1mm layer, 2 walls, 100% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
71
173
41
3
574
322
Released
Description
I created this profile to print clear PETG as close as possible to glass clear.
In the pictures I'm using Bambulab PETG Transparent.
Comment & Rating (41)
All
When loading this profile, only PLA is shown in the filaments. Your profile does not account for PETG and any of the specific cooling settings in the filament section.
1
Reply
did you figure it out
0
Reply
Boosted
Print Profile
0.1mm layer, 2 walls, 100% infill
turns out great, a lot of sanding and it is almost 100% clear. There is only a little shadow of layerlines. Pic. 1 blocked light with electrical tape on the edges. pic. 2 no blocking of the light.
(Edited)
1
Reply
Print Profile
0.1mm layer, 2 walls, 100% infill
Took awhile, I used the Bambu clear PETG and not all that clear. Might try again when I get a bigger nozzle and enclose my P1P.
0
Reply
Print Profile
0.1mm layer, 2 walls, 100% infill
prints well as-is. 0.4 nozzle. better with dry filament. some sanding for better results.
0
Reply
Print Profile
0.1mm layer, 2 walls, 100% infill
Used this profile to try and print a transparent cap for my X-acto knife. Worked fairly well.
0
Reply
Print Profile
0.1mm layer, 2 walls, 100% infill
tried on esun natural petg, didn’t change anything
0
Reply
Print Profile
0.1mm layer, 2 walls, 100% infill
Very interesting, still some visible lines but there is some really clear parts vertically through the rectilinear infill.
0
Reply
I downloaded this but there's no PETG filament in the project
2
Reply
did you figure it out
0
Reply
Replying to @aTroy3D
I think I didn;t have PETG selected in the filament selection. I wouldn't have thought that would matter though. Thanks.
0
Reply
Print Profile
0.1mm layer, 2 walls, 100% infill
Used precisely the same profile but didn’t really obtain glass-like results. Might be to do with the filament I used (Giantarm).
0
Reply
it was made for bambulab clear
(Edited)1
Reply
Print Profile
0.1mm layer, 2 walls, 100% infill
Did not work for my setup
0
Reply
License
This user content is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld