For a long time I've been wanting to make this myr head deck box. I was finally able to get the head shape pretty good. This deck box fits 100+ single sleeved cards. I couldn't fit double sleeved card capacity while also fitting on the A1 Mini build plate so I opted for the smaller version. There are spots for 8(total) 10mmx2mm magnets. I glued them in with super glue. I might try hot glue the next time. I also used no supports so it is possible to print this without supports but just keep in mind this is the finish I achieved. My decks aren't that expensive so I'm not too worried about it. If you are I have made a support print profile as well. Also if anyone has advice on better bridge settings I'd love to hear them.