这是一次好玩的尝试，并不是一个非常实用的鼠标

This Print file is just for fun. Not a very pratical mouse LOL

但购买官方打印机总会送半卷绿色PLA，今天看到官方的Logo发现……

The half-roll green PLA always goes along woth the printer package. Early in the morning I hold the green PLA next to the Logo and found………..

这不就是鼠标的形状嘛!!!

This Logo is a Fxcking mouse!!!

于是就把Logo做成了鼠标哈哈哈

Then I turn the Logo into this funny mouse HAHAHAHAHAHAHAHAHA.

万一你真的想要尝试做一个，组装说明如下 :

In case you want to make one for your own, Here's the assembly instruction :

• 点502加强锁孔 Use super glue to strengthen the screw hole

• 用502加强定位桩，官方板子孔位太TM小了 Use super glue to strengthen the pins. The holes on the official kit are too fxcking small!

• 放上开关、透镜、电路板、滚轮、电池等配件 Put everything on the base, you can reference to the offical manual

• 拿出盖板，在红圈处点上502 Red circle for tiny amount of super glue

• 放入中间固定件，绿与黑的锁孔要贴合粘黏 Place the inner part. Notice the 2 holes of the black Inner part has to attach to the 2 holes of the cover

• 用力从背部锁紧螺丝 Screw HARD form the back

• 在正面点几滴502 Drop a little love at the font

• 粘上左右键 Glue the left right button wuyeah

• 中键插进去 Go in from the middle

• 最后黏上黑竹 Finally, give the Bambu a little touch

• 好啦! TADA!

拓竹应该把这个变成官方版本才对，竹味满满

The Bambu Lab should make this as the offical model. So Bambu, so slick.