➡️ ⚙️ ⚒️ 📏 Checkout the entire MFT Tools and Accessories collection

20mm MFT Reamer & Chamfering tool, it let you produce a clean accurate 20mm hole with chamfer on your MFT table holes.

The chamfer (only) tool is available here : https://makerworld.com/en/models/480073#profileId-391546 

Note: This is a REAMER, not a drill bit, the hole must be less than 3% smaller to work properly.

It will help you to make accurate hole (very close to 20.00mm), or restore holes messed up by the time (glue, finishing products, etc…)

Tested with accurate UJK Aluminum Close Fit Chamfer Dogs

I also used the UJK Reamer and Chamfer tool as reference, result are very close than the original tool

You will need :

• (3x) M4x10mm Countersunk screw
• (1x) 12x12x1.5 Carbide Insert
• (1x) 30x12x1.5 Carbide Insert
• An old drill bit

Enjoy!