Corner radius router jig with inserts - Clampable
Remixed by
Copyright Claim
Corner radius router jig with inserts - Clampable
Remixed by
Boost
15
35
1
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
29.1 h
8 plates
Boost
15
35
1
0
23
11
Released
Description
Corner radius router jig with changeable inserts. Can be clamped to the work piece to use with a handheld router.
The base is design to accommodate track saw clamps (slots for the clamps are 12mm wide, 7.5mm deep)
Inserts are available in metric and imperial measurements.
The base requires some support for the clamp slots.
Print the screw in PETG(or ABS/ASA), 100% infill . Don't over tighten it or it might snap.
Comment & Rating (1)
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld