Filament Dry Box (4 Filaments) IKEA SAMLA 22L
Copyright Claim
Filament Dry Box (4 Filaments) IKEA SAMLA 22L
Boost
7
19
4
Print Profile(2)
Version 3 Complete (With Supports)
Designer
10.1 h
4 plates
New Foot
Designer
3.1 h
2 plates
Open in Bambu Studio
Boost
7
19
4
0
14
1
Released
Description
UPDATE:
Added new Bottoms with the installation of m3 screws
for the Version m3 screws: need to drill holes into the bottom
I tried many DryBox solution, but always have issues with the spools on the rods. So to make it easier, I use extensions for the bearings.
Requirements:
1x IKEA Samla 22L Box with Lid (Lid with insulation strip)
16x 608ZZ Bearings (22x8x7)
2x 8mm Threaded Rods (320mm each)
Double sided Tape (Adhesion bottom part onto the box)
Instructions:
-insert the top and bottom part together
-insert 2 bearings onto the spool holder each. Tight fit. Might use some strength.
-put 4 spool holders into the rod
-put the rod onto the top part
-with double sided tape on the bottom part, insert into the box
Comment & Rating (4)
All
The print profile is no longer public
3rd time never success.
The designer has replied
0
Reply
youll need to add some supports. If you use tree supports it will turn out best.
0
Reply
Replying to @user_366644978
ohh, cause ur setting didnt turn on support, i though no need. Tree support better?
0
Reply
Replying to @lingjia92
Updated a new Version 3 with tree support. Tree Support will need less filament and works better regards removing. And you can trim the inside. You can trim the inside off.
(Edited)0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld