Achsen & Wellenprüfstand
Benötigt werden 4 Kugellager 608 und 2 Stück M5 Inserts.
Alternativ kann man sich auch den Standfuß mit M5 Gewinde drucken.
Empfehlen würde ich Gewinde-Insert zu benutzen und ggf. richtige M5 Schrauben.
Axles & shaft test stand
You need 4 ball bearings 608 and 2 M5 inserts.
Alternatively, you can also print the stand with M5 thread.
I would recommend using threaded inserts and, if necessary, the correct M5 screws.
#########################################
Gedruckt in PLA mit Layerhöhe 0,16
Erste Schicht 50mm/s
Außenwand 60mm/s
Alternativ im Bambu-Slicer das folgende Profil wählen: 0.16mm Optimal @BBL X1C und dort die Geschwindigkeit der Außenwand auf 60mm/s anpassen.
Printed in PLA with layer height 0.16
First layer 50mm/s
Outer wall 60mm/s
Alternatively, select the following profile in Bambu-Slicer: 0.16mm Optimal @BBL X1C and adjust the speed of the outer wall to 60mm/s.