I created this gasket for a better seal between the housing and carbon pellet “CMag” that air gets pulled through.
The gasket needs to be printed in TPU filament.
Please use the settings from the included print file.
This prints in vase mode at a slower speed, 1 perimeter at, 0.55mm line width, and 0.20mm layer height.
After printing, there might be some small strings that you can remove with sidecutters.
Installation
1. Press the gasket into the bottom of the BenoBox section labeled “CARBON”.
The flat surface (which was the first layer) should be facing down.
2. Insert the CMag and give it a gentle press after it reaches the bottom to ensure everything is snug.