This kit contains an horizontal spinner, a ptfe tube passthrough and a click-on frame for an humidity meter. The base of the horizontal spinner has an inner diameter of approximatly 6.4 centimeters. I got mine from Aliexpress (see the link below), if you got a similar one than this should fit.
Assembly
Passthrough
With my Dremel I modified one of the trays, so that I only had the brim left. I used the dremel tool to make a 14mm hole in this brim. I mounted the passthrough in the hole as shown in the picture.
The passthrough consists of two rings, a screw, and a nut. The screw has an inner thread that fits a pc4-m10 connector (see link below) the two rings have an arrow printed on the side that should point to the direction the filament travels to the printer. This should help with determining which ring goes on the outside an which in the inside of the dehydrator.
Thrust bearings
The thrust bearings should be assembled according to the piuctures below.
In the picture its assembled upside down. First the race, then the cage, then the tapered rollers, and then again a race. Carefully, turn them right-side-up .
Spinner
Put one of these thrust bearings on the bottom part of the spinner.
On this goes the middle part.
Then the second thrust bearing,
and lastly screw the top part on.
The humity meter can be clicked in the frame, the frame clicks on the bars of the tray thats still intact. This tray goes on the bottom.
