Project: Hot Springs AR 6 Church Hueforge.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
If changing size . . . only change X and Y, not Z.
The Model is 172x230mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.6mm and the Actual Depth is 2.7mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Matte White Transmission Distance: 3.5
This print uses 4 unique filaments
Swap Instructions:
Start with Black
At layer #14 (1.2mm) swap to Blue Gray
At layer #16 (1.36mm) swap to Gray
At layer #23 (1.92mm) swap to White for the rest.