Note: I had a bad bed adhesion on the right corner, that is why I have a little black part there.
Based on your filament choice the result may vary.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

The Model is 150x148.94mm in size
You may print at higher layer heights below the Min Depth of 0.52mm
The Max Depth is 2.5mm and the Actual Depth is 2.5mm

Filaments Used:
    PLA+ Sunlu Black Transmission Distance: 0.6
    PLA+ Elegoo Red Transmission Distance: 3.5
    PLA+ Elegoo Yellow Transmission Distance: 4
    PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #10 (0.92mm) swap to Red
    At layer #14 (1.24mm) swap to Yellow
    At layer #21 (1.8mm) swap to Jade White for the rest.