A1/Mini AMS Plug
Copyright Claim
A1/Mini AMS Plug
Boost
117
258
67
Print Profile(2)
Original, 0.2mm layer, 2 walls, 15% infill
Designer
10 min
1 plate
Fast & Clean // 0.28mm layer // 2 walls // 15% infill
8 min
1 plate
Open in Bambu Studio
Boost
117
258
67
21
427
157
Released
Description
This little plug is super easy to make and takes less than 10 min to print!
Do you have an A1/Mini and don't have the AMS system? You might notice the little black nubs where the PTFE tubes connect to the hot end vibrate and make noise during pre-print. This plug will stop the vibrating and keep dust out of them!
If you want to make sure your plug is perfectly flat, printing with a brim should work.
Comment & Rating (67)
All
Print Profile
Original, 0.2mm layer, 2 walls, 15% infill
great little thing. snug fit
1
Reply
Print Profile
Original, 0.2mm layer, 2 walls, 15% infill
Perfect print! Thanks :)
(Edited)
0
Reply
Boosted
Print Profile
Original, 0.2mm layer, 2 walls, 15% infill
nice small print
0
Reply
Print Profile
Original, 0.2mm layer, 2 walls, 15% infill
cute and functional!
0
Reply
super functional, saves the dust getting into my A1 mini
0
Reply
Print Profile
Original, 0.2mm layer, 2 walls, 15% infill
perfect fit
0
Reply
Boosted
Great idea, many thanks for that
(Edited)
0
Reply
Print Profile
Original, 0.2mm layer, 2 walls, 15% infill
fast, easy did what it says it does.
0
Reply
Print Profile
Original, 0.2mm layer, 2 walls, 15% infill
works fine, easy print!
0
Reply
Print Profile
Original, 0.2mm layer, 2 walls, 15% infill
Nice
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
© 2024 MakerWorld