I have made this simple stand for a commonly available, cheap hygro- and temperature-sensor. By default, I have angled the stand under 60 degrees and it currently serves me well, on my desk, to show me the room temperature and humidity of my office.
By the way, the texture on the front of my print is the result of using a textured PEI plate.
Updates
2024-06-18: I have added a parameter to add M3 screwholes in the base.
2024-06-18: I have added additional parameters to tinker with the cutout for the hygrometer.
What you additionally need:
I used the following settings to print in 1.75 PLA with 0.4 nozzle:
layer height | 0.2mm |
walls | 2 |
top shell layers | 2 |
bottom shell layers | 2 |
infill | 15% grid |
raft or brim | no |
support | not if oriented right way up (hole should be on the bed) |