foldable 18 slots PEI build plate holder Fixed (Model are fine, slicer merge wrong a little before)
Copyright Claim
foldable 18 slots PEI build plate holder Fixed (Model are fine, slicer merge wrong a little before)
Boost
10
13
7
Print Profile(2)
0.2mm layer, 4 walls, 15% infill
Designer
4.9 h
1 plate
0.2mm layer, 2 walls, 15% infill
3.3 h
1 plate
Boost
10
13
7
0
48
11
Released
Description
Foldable 18 slots PEI build plate holder. Magnet install optional. Remember add support under. Best use PETG,ABS filament.
Comment & Rating (7)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Das Modell lässt sich leider nicht ausklappen. Was die funktion nicht einschränkt. Denke das liegt an meinem alten Filament. Werde es bei Zeiten nochmal drucken.
0
Reply
It,s a little tracky to remove supports. Just want to make one use for dry pei plates after a wash. Mainly use in my little print farm.
0
Reply
Sorry bro. I double checked...Slicer merge the inner erge together. My bad. I print with abs before, so don't found out because
It's tough enough to be forced open.... Sorry again. Now is fixed.
0
Reply
doesn't work properly, it breaks when you put the print trays in, I put it in the bin
The designer has replied
0
Reply
Sorry bro. I double checked...Slicer merge the inner erge together. My bad. I print with abs before, so don't found out because
It's tough enough to be forced open.... Sorry again. Now is fixed.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld